Supero SUPERO SuperServer 5037MC-H8TRF, Руководство пользователя

Страница: 42 / 98

5-8
S
UPER
S
ERVER 5037MC-H8TRF User's Manual
5-7 Adding PCI Add-On Cards
The 5037MC-H8TRF supports one low-pro fi le PCI card in each of the eight nodes.
To install an expansion card, follow the instructions below.
Installing an Add-on Card
1. Power-down the node using that node's individual power button and remove it
as described in Chapter 6.
2. Open the PCI slot clip and remove the PCI slot shield.
3. Open the PCI slot clip in the rear of the motherboard node.
4. Remove the PCI slot shield.
5. Insert the expansion card into the riser card which is pre-installed on the
motherboard (if desired the riser card may be removed from the motherboard
by removing the riser card screw)
6. Slide the expansion cards bracket into the PCI card slot and fi t it with the
opening in the rear of the node.
Guidelines for Populating Memory
When installing memory modules, the DIMM slots should be populated in the fol-
lowing order: DIMM1A, DIMM2A, DIMM1B and DIMM2B.
•
Always use DDR3 DIMM modules of the same size, type and speed.
•
Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed
of the slowest DIMM.
•
Although the motherboard can support one or three DIMM modules installed,
memory should be installed in pairs for best performance.
Recommended Population (Balanced)
DIMM2B Slot DIMM2A Slot DIMM1B Slot DIMM1A Slot Total System Memory
2GB DIMM 2GB DIMM 4GB
2GB DIMM 2GB DIMM 2GB DIMM 2GB DIMM 8GB
4GB DIMM 4GB DIMM 8GB
4GB DIMM 4GB DIMM 4GB DIMM 4GB DIMM 16GB
8GB DIMM 8GB DIMM 16GB
8GB DIMM 8GB DIMM 8GB DIMM 8GB DIMM 32GB