Supero SUPERO SuperServer 5037MC-H8TRF, Руководство пользователя

Страница: 39 / 98

Chapter 5: Advanced Motherboard Setup
5-5
CPU properly
installed
Make sure "A"
points are under B
A
B
Load lever locked
into place.
Installing a Heatsink
1. With the node removed, remove the air shroud as described in Section 6-7.
2. Do not apply any thermal grease to the heatsink or the CPU die; the required
amount has already been applied.
3. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the motherboard and the heatsink bracket underneath.
4. Screw in two diagonal facing screws until just snug (do not over-tighten the
screws to avoid possible damage to the CPU.)
5. Finish the installation by fully tightening all four screws.
6. Reverse the order of this procedure to remove a heatsink.
Figure 5-2. Installing a Heatsink