Supero SUPER P6DLE, Руководство пользователя

Страница: 50 / 66

2-18
SUPER P6DLS/P6DLE/P6SLS/P6SLA User’s Manual
2-6 Installing/Removing the DIMM Modules
SUPER P6DLS/P6DLE/P6SLS can accommodate a maximum of 1
GB EDO or 512 MB SDRAM, using standard 168-pin 3.3V unbuf-
fered DIMM memory modules. SUPER P6SLA can accommodate a
maximum of 768 MB EDO or 384 MB SDRAM.
There are three types of EDO and SDRAM DIMM modules: x4, x8
and x16. If you are using the x4 type, you can populate the DIMM
slots with either 4 single-sided memory modules or 2 double-sided
memory modules. For memory configurations of 512 MB EDO
DIMMs or higher, it is recommended to use the x8 or x16 type of
memory. It is not recommended to mix EDO DIMM modules with
SDRAM DIMM modules.
There are no jumpers needed to configure the on-board memory.
Memory timing requires 70ns or faster for EDO memory. Refer to
Figure 2-7 and the instructions below for installing or removing
DIMM modules.
CAUTION
Exercise extreme care when installing or removing the
DIMM modules to prevent any possible damages.
DIMM Module Installation
1. Insert DIMM modules in Bank 0 through Bank 3 as required
for the desired system memory.
2. Insert each DIMM module vertically into its socket. Pay
attention to the two notches to prevent inserting the DIMM at a
wrong position. The component side of the DIMM module
must face the CPU socket. The latter statement is applicable
for DIMMs with components on one side only.
3. Gently press the DIMM module until it snaps upright into place
in the socket.