Supero SUPER P3TDDE, Руководство пользователя

Страница: 33 / 96

Chapter 2: Installation
2-13
CMOS Clear
Refer to Table 2-21 for instruc-
tions on how to clear CMOS. Al-
ways remove the AC power cord
from the system before clearing
CMOS.
Note: For an ATX power supply, you
must completely shut down the sys-
tem, remove the AC power cord, then
use JBAT1 to clear CMOS. Replace
JBAT1 back to the pin 1-2 position
b e f o r e p o w e r i n g u p t h e s y s t e m
again. Do not use the PW_ON con-
nector to clear CMOS.
Position
1-2
Position
2-3
Nor
m
al
CMO
S
Cl
ear
Keyboard Wake-Up
The JPWAKE jumper (JP2) is used
together with the Keyboard Wake-
Up function in BIOS. Enable both
the jumper and the BIOS setting to
allow the system to be woken up
by depressing a key on the key-
board. See Table 2-22 for jumper
settings.
Note: Your power supply must meet ATX
specification 2.01 or higher and supply 720
mA of standby power to use this feature.
T able 2-21
CMOS Clear Jumper Settings
(JBT 1)
Jumper
Position
1-2
2-3
Definition
Normal
CMOS Clear
Jumper
Position
1-2
2-3
Definition
Disabled
Enabled
T able 2-22
Keyboard W ake-Up
Jumper Settings (JP2)
Watch Dog Enable
This jumper is used to enable or dis-
able the Watch Dog function. This
jumper is used together with the
Watch Dog enable function in BIOS.
Enable both the jumper and the
BIOS setting to use the Watch Dog
feature. See the table on the right
for pin definitions.
Jumper
Position
Open
Closed
Definition
Disabled
Enabled
Watch Dog Enable
Jumper Settings (JP10)