Supero SUPER 370DL3, Руководство пользователя

Страница: 78 / 94

S
UPER 2DL3/370DL6/370DL3/370DLE Manual
4-18
BIOS
EPP Version
The settings are
Enabled
and
Disabled
.
Note: The Optimal and
Fail-Safe default settings are N/A.
Parallel Port IRQ
This option specifies the IRQ to be used by the parallel port. The
settings are 5 and 7 .
Parallel Port ECP DMA Channel
This option is only available if the setting of the parallel port mode
option is ECP . The settings are 0 , 1 , 2 , 3 , 5 , 6 and 7 .
Onboard IDE
This option enables the IDE (Hard Disk Drive Controller) device(s) on the
motherboard. The options are
Enabled
and
Disabled
.
Auto-Detect Hard Disks
This section allows BIOS to look for and configure any hard disk drives on
your system. After highlighting this option, hit <Enter> and wait momentarily
while BIOS performs the auto-detect. You will soon see the disk drives
appear properly configured.
Change User Password
Change Supervisor Password
The system can be configured so that all users must enter a password
every time the system boots or when the AMIBIOS setup is executed.
You can set either a Supervisor password or a User password. If you
do not want to use a password, just press <Enter> when the password
prompt appears.
The password check option is enabled in the Advanced Setup by
choosing either Always or Setup . The password is stored in CMOS RAM.
You can enter a password by typing it out on the keyboard or by
selecting each letter via the mouse or a pen stylus. Pen access must be
customized for each specific hardware platform.