Supero PDSMP-8, Руководство пользователя

Страница: 24 / 98

2-6
PDSMP-8/PDSMP-i User's Manual
To Install:
Insert module verti-
cally and press down
until it snaps into
place. Pay attention
to the notch.
Figure 2-2. DDR 2 Installation
To Remove:
Use your thumbs to
gently push each
release tab outward
to release the DIMM
from the slot.
Top View Of DDRII Slot
DDR2
2-4 Installing DDR 2 Memory
Memory Module Installation (See Figure 2-2)
Exercise extreme care when installing or removing memory modules
to prevent any possible damage.
1. Insert each DDR 2 memory module vertically into its slot. Pay attention to the
notch along the bottom of the module to prevent inserting the module incor-
rectly. (See support information below.)
2. Gently press down on the memory module until it snaps into place.
Support
The PDSMP-8/i supports Dual channel, ECC unbuffered DDR 2 667/533/400
SDRAM. Both interleaved and non-interleaved memory are supported, so you
may populate any number of DIMM slots. (Populating DIMM#1A,DIMM#1B,
and/or DIMM#2A, DIMM#2B with memory modules of the same size and of
the same type will result in dual channel, two-way interleaved memory which
is faster than the single channel, non-interleaved memory. When ECC memory
is used, it may take 25-40 seconds for the VGA to display.)
(*Note: 1. Due to chipset limitation, 8GB Memory can only be supported by the
following operating systems:
32-Bit: Windows 2000 Advanced Server, Windows Server 2003 Enterprise
Edition;
64-Bit: Windows Server 2003 Standard x64 Edition, Windows XP Professional
x64 Edition, Windows Server 2003 Enterprise x64 Edition.
2. You may install a maximum of 2GB DIMMs on each slot; however, only DDR 2
533 2GB density modules are available for this confi guration.
3. Some old-version of DDR 2-667 may not match Intel's On-Die-Tempeature re-
quirement and will automatically be down-graded to run @ 533 MHz, If this
occurs, contact your memory vendor to check the ODT value.)