Supero 5037MR, Руководство пользователя

Страница: 47 / 106

Chapter 5: Advanced Motherboard Setup
5-13
5-9 Connector De fi nitions
TPM Header
This header is used to connect a
Trusted Platform Module (TPM), which
is available from a third-party vendor.
A TPM is a security device that allows
encryption and authentication of hard
drives. It enables the motherboard to
deny access if the TPM associated
with the hard drive is not installed in
the system. See the table on the right
for pin de
fi nitions.
Trusted Platform Module Header
Pin De fi nitions
Pin # De fi nition Pin # De fi nition
1 LCLK 2 GND
3 LFRAME 4 No Pin
5 LRESET 6 VCC5
7 LAD3 8 LAD2
9 VCC3 10 LAD1
11 LAD0 12 GND
13 RSV0 14 RSV1
15 SB3V 16 SERIRQ
17 GND 18 CLKRUN
19 LPCPD 20 RSV2
IF + POWER
This edge connector, located on the opposite end of the motherboard from the I/O
back panel, is used to connect the motherboard to the backplane of the server
chassis. Through this connector, the motherboard will receive its power and com-
municate with the rest of the system (hard drives, warning lamps, etc).
Universal Serial Bus (USB)
Two Universal Serial Bus ports (USB
2~3) are located on the on the moth-
erboard. These are available on a
header. There are also two ports
(USB 0/1) available through the KVM
port (Cables are not included). See the
table on the right for pin de
fi nitions.
USB Header
Pin De fi nitions
Pin # De fi nition Pin # De fi nition
1 +5V 6 +5V
2 USB_PN 7 USB_PN
3 USB_PP 8 USB_PP
4 Ground 9 Ground
5 NA 10 Key
Serial_Link-SGPIO
Pin De fi nitions
Pin# De fi nition Pin De fi nition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
T-SGPIO (T-SGPIO2)
One T-SGPIO (Serial-Link General
Purpose Input/Output) header is
supported on the motherboard. This
header is used to communicate with
the enclosure management chip in
the system. See the table on the right
for pin de
fi nitions. Refer to the board
layout below for the location of the
header.