Supero 2027R-WRF, Руководство пользователя

Страница: 79 / 132

Chapter 5: Advanced Serverboard Setup
5-27
LAN Enable/Disable
JPL1 enables or disables the GLAN
Port1/GLAN Port2 on the motherboard.
See the table on the right for jumper
settings. The default setting is Enabled.
LAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting De fi nition
1-2 Enabled (default)
2-3 Disabled
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
Pins 1-2 to reset the system if an ap-
plication hangs. Close Pins 2-3 to gen-
erate a non-maskable interrupt signal
for the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
Watch Dog Enable/Disable
Jumper Settings (JWD)
Jumper Setting De fi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper JPG1 allows the user to
enable the onboard VGA connector.
The default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable
the embedded the Renesas BMC
(Baseboard Management) Controller
to provide IPMI 2.0/KVM support on
the motherboard. See the table on the
right for jumper settings.
BMC Enable/Disable
Jumper Settings (JPB1)
Jumper Setting De fi nition
Pins 1-2 BMC Enable
Pins 2-3 Normal (Default)
I2C to PCI-Exp
Jumper Settings
Jumper Setting De fi nition
Closed Enabled
Open Disabled (Default)
I2C Bus to PCI-Exp. Slots
Jumpers JI
2
C1 and JI
2
C2 allow you
to connect the System Management
Bus (I
2
C) to PCI-Express slots. The
default setting is Open to disable the
connection. See the table on the right
for jumper settings.