Supermicro SuperServer 8028B-C0R3FT, Руководство пользователя

Страница: 76 / 142

5-26
SUPERSERVER 8028B-TR3F/C0R3FT User's Manual
LAN1/2 Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Normal
BMC Enable
Jumper JPB1 is used to enable or disable
the embedded ASpeed AST2400 BMC
(Baseboard Management Controller)
that provides IPMI 2.0/KVM support on
the motherboard. See the table on the
right for jumper settings.
LAN Enable/Disable
JPL1 enables or disables Gigabit_LAN
ports on the X10QBL-CT, while JPTG1
enables or disables 10G-LAN ports on
the X10QBL-T. See the table on the
right for jumper settings. The default
setting is Enabled.
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that will reboot the system when a
software application hangs. Close pins
1-2 to reset the system if an application
hangs. Close pins 2-3 to generate a
non-maskable interrupt signal for the
application that hangs. See the table
on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
VGA Enable
Jumper JPG1 allows the user to
enable the onboard VGA connector.
The default setting is on pins 1-2 to
enable the connection. See the table
on the right for jumper settings.