Supermicro SuperServer 8028B-C0R3FT, Руководство пользователя

Страница: 55 / 142

Chapter 5: Advanced Serverboard Setup
5-5
5-4 Installing the Processor and Heatsink
Warning: When handling the processor package, avoid placing direct pressure on
the label area. Also, improper CPU installation or socket/pin misalignment can cause
serious damage to the CPU or the motherboard and may result in RMA repairs. Be sure
to read and follow all instructions thoroughly before installing your CPU and heatsink.
Notes:
1. Always connect the power cord last, and always remove it before adding,
removing or changing any hardware components. Make sure that you install
the processor into the CPU socket before you install the CPU heatsink.
2. If you buy a CPU separately, make sure that you use an Intel-certified multi-
directional heatsink only.
3. Make sure to install the motherboard into the chassis before you install the
CPU heatsink.
4. When receiving a motherboard without a processor pre-installed, make sure
that the plastic CPU socket cap is in place, and none of the socket pins are
bent; otherwise, contact your retailer immediately.
5. Refer to the Supermicro website for updates on CPU support.
6. With the CPU inside the socket, inspect the four corners of the CPU to make
sure that the CPU is properly installed.
7. Close the load plate with the CPU inside the socket. Lock the lever labeled
'Close 1st' first, then lock the lever labeled 'Open 1st' second. Use your
thumb to gently push the load levers down to the lever locks.
Installing the E7-8800 v3 or E7-4800 v3 Series Processor
1. There are two load levers on the processor socket. To open the socket lever,
first press and release the load lever labeled 'Open 1st'.
Press down on
Load Lever labeled
'Open 1st'.
1 2
OPEN 1st
OPEN 1s
t