Supermicro SUPERSERVER 6021i, Руководство пользователя

Страница: 25 / 110

Chapter 2: Server Installation
2-9
6. Check all cable connections and airflow:
Make sure all power and data cables are properly connected and not
blocking airflow. See Section 5-3 for details on cable connections. Also,
check the air seals for damage. The air seals are located under the
blower fan and beneath the frame cross section that separates the drive
bay area from the motherboard area of the chassis.
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the IDE
drives and backplane have been properly installed and all connections
have been made.
1. Accessing the drive bays:
All drives can be accessed from the front of the server. For servicing
the CD-ROM and floppy drives, you will need to remove the top chassis
cover. The IDE disk drives can be installed and removed from the front
of the chassis without removing the top chassis cover. The 5.25" drive
bay cover can be removed by pressing the tab on the corner of the drive
bay and then push the bay outward from inside.
2. Installing components into the 5.25" drive bay:
Remove the drive bay cover by pressing the tab as decribed in the
previous section. Remove the drive bay rails as shown in Figure 2-6.
Install the rails onto the new component and then slide the new compo-
nent into the drive bay until you hear a clicking sound from the tab.
3. Installing CD-ROM and floppy disk drives:
Refer to Section 6-4 if you need to reinstall a CD-ROM and/or floppy disk
drive to the system.
4. Check the IDE disk drives:
Depending upon your system's configuration, your system may have one
drive already installed. If you need to install an IDE drive, please refer to
Section 6-4. Be certain that the server's electrical power is "off" before
attempting to change an IDE hard disk drive -- they are not hot-
swappable.