SuperServer 6019P-MT/MTR User's Manual
36
Figure 3-4. Removing a Drive Carrier
3.4 Chassis Components
Hard Drives
Your server may or may not have come with hard drives installed. Up to four 3.5" hot-swap
hard drives are supported by the chassis.
The SATA drives are mounted in drive carriers to simplify their installation and removal from
the chassis. (Both procedures may be done without removing power from the system.)
Removing a Hot-Swap Drive Carrier
1. Push the release button on the carrier.
2. Swing the handle fully out.
3. Grasp the handle and use it to pull the drive carrier out of its bay.
Mounting a Drive in a Drive Carrier
1. To add a new drive, install it into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
2. Secure the drive to the carrier with the screws provided, then push the carrier
completely into the drive bay. You should hear a *click* when the drive is fully inserted.
This indicates that the carrier has been fully seated and connected to the HDD
backplane, which automatically makes the power and logic connections to the hard
drive.
Release Button
