Supermicro SUPERSERVER 6018R-TDTP, Руководство пользователя

Страница: 16 / 75

Chapter 3: System Interface
3-2 3-3
S
UPER
S
ERVER 6018R-TDTP/TDTPR User's Manual
NIC1
Indicates network activity on LAN1 when flashing.
3-3 Control Panel LEDs
The control panel located on the front of the SC815TQ chassis has five LEDs.
These LEDs provide you with critical information related to different parts of the
system. This section explains what each LED indicates when illuminated and any
corrective action you may need to take.
1
2
Figure 3-1. Information LED States
Note: deactivating the UID LED must be performed in the same way it was activated.
(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and
not with the UID button.)
Information LED
This LED will be solid blue when the UID function has been activated. When this
LED flashes red, it indicates a fan failure. When red continuously it indicates an
overheat condition, which may be caused by cables obstructing the airflow in the
system or the ambient room temperature being too warm. Check the routing of
the cables and make sure all fans are present and operating normally. You should
also check to make sure that the chassis covers are installed. Finally, verify that
the heatsinks are installed properly (see Chapter 5). This LED will remain flashing
or on as long as the indicated condition exists.
NIC2
Indicates network activity on LAN2 when flashing.
HDD
Indicates IDE channel activity. On the SuperServer 6018R-TDTP/TDTPR, this light
indicates SATA and/or DVD-ROM drive activity when flashing.
Power
Indicates power is being supplied to the system's power supply units. This LED
should normally be illuminated when the system is operating.
Universal Information LED States
State Indication
Fast Blinking Red (1x/sec) Fan Fail
Solid Red CPU Overheat
Slow Blinking Red (1x/4 sec) Power Fail
Solid Blue
Local UID Button Depressed
Blinking Blue IPMI-Activated UID