15
Chapter 1: Introduction
Quick Reference Table
Jumper
Description
Default Setting
JBT1
CMOS Clear
Open (Normal)
JPG1
VGA Enable/Disable
Pins 1-2 (Enabled)
JPME2
Manufacturing Mode
Pins 1-2 (Normal)
JVRM1/JVRM2
VRM SMB Clock (to BMC or PCH)
Pins 1-2 PCH (Normal)
Pins 2-3 BMC (Normal)
JWD1
Watchdog Timer
Pins 1-2 (Reset)
Connector
Description
BT1
Onboard Battery
COM1/COM2
COM (Port), COM2 (Header)
FAN1~FAN4, FANA/FANB
System/CPU Fan Headers
I-SATA0 ~ I-SATA5
Intel Serial SATA (SATA 3.0) Ports (6Gb/s)
I-SGPIO1, I-SGPIO2
Serial General Purpose I/O Headers
BMC_LAN
Dedicated BMC LAN Port
JF1
Front Control Panel Header
JL1
Chassis Intrusion Header
JPCIE4
PCH SLOT4 PCIe 3.0 x2 (IN x4)
JPCIE5
CPU SLOT5 PCIe 4.0 x8 (It will run at PCIe 3.0 x8 when a Pentium processor is installed)
JPCIE6
CPU SLOT6 PCIe 4.0 x8 (IN x16)
(It will run at PCIe 3.0 x8 when a Pentium processor is installed)
JPCIE7
CPU SLOT7 PCIe 4.0 x4 (IN x8)
(SLOT7 will be disabled when a Pentium processor is installed)
JPWR1
24-pin ATX Main Power Connector (Required)
JPWR2
+12V 8-pin CPU power Connector (Required)
JSD1/JSD2
SATA DOM Power Connector
JSTBY1
Standby Power Header (5V)
JIPMB1
4-pin external BMC I²C header (for an IPMI card)
JTPM1
Trusted Platform Module/Port 80 Connector
JUIDB1
UID Switch
LAN1/LAN2
Gigabit (RJ45) Ports
M.2-P, M.2 NVME
M.2 PCIe 3.0 x4 Slot (Supports 22110/2280 FF)
JPI²C1
Power SMB (System Management Bus) I²C Header
USB0/1
Back Panel USB 2.0 Ports
USB2/3
Front Accessible USB 2.0 Ports
USB4/5
Back Panel USB 3.2 Gen1 Connector
USB6/7
Front Accessible USB 3.2 Gen1 Ports via Headers
USB8
Front Accessible USB 3.2 Gen1 Port (Type-A)
VGA
VGA Port
Note:
Table continues on the next page.
