Supermicro SUPERSERVER 5018A-LTN4, Руководство пользователя

Страница: 61 / 118

Chapter 5: Advanced Serverboard Setup
5-17
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
PCI Slot SMB Enable
(JI2C) Jumper Settings
Setting Defi nition
Short Enabled
Open Disabled (Default)
PCI Slot SMB Enable (JI2C1/JI2C2)
Use Jumpers I 2 C1/I 2 C2 to enable
PCI SMB (System Management
Bus) support to improve system
management for the onboard PCI-E
slot. See the table on the right for
jumper settings.
Watch Dog Timer Enable
Watch Dog (JWD1) is a system monitor
that can be used to reset the system
or enter NMI when the Timer expires.
Close pins 1-2 to reset the system if
an application hangs. Close pins 2-3
to generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog may be enabled
in the BIOS Setup. The default timer is
around 5 minutes.
Watch Dog
Jumper Settings
Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disable
LAN Ports Enable/Disable
Jumper JPL1 enables or disables
E t h e r n e t L A N p o r t s o n t h e
motherboard. See the table on the
right for jumper settings. The default
setting is enabled.
GbE LAN Enable
Jumper Settings
Setting Defi nition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled