Supermicro SUPERSERVER 4028GR-TR, Руководство пользователя

Страница: 50 / 140

5-2
SUPERSERVER 4028GR-TR(T)(2) User's Manual
5-2 Connecting Cables
Assuming the X10DRG-O(T)+ motherboard is installed, the next step is to connect
the cables to the board. These include the data (ribbon) cables for the peripherals
and control panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been
carefully routed to prevent them from blocking the flow of cooling air that moves
through the system from front to back. If you need to disconnect any of these cables,
you should take care to keep them routed as they were originally after reconnecting
them. Make sure the red wires connect to the pin 1 locations. See the layout in
section 5-6 for connector locations.
Important! Make sure the the cables do not come into contact with the fans.
Connecting Power Cables
The motherboard has many power connectors. See Section 5-7 for power connector
pin definitions.
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure
5-4 for the pin locations.
All JF1 wires have been bundled into a single ribbon cable to simplify this
connection. Make sure the red wire plugs into pin 1 as marked on the board. The
other end connects to the Control Panel PCB board, located just behind the system
status LEDs on the chassis. See Section 5-7 for details.