22
SuperServer 1019D-FRN8TP User's Manual
Chapter 3
Component Installation and Maintenance
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and part
numbers given.
Remove power from the system and remove the top cover before installing or replacing
components. Refer to Section 3.1 and Section 3.2.
3.1 Removing Power
Use the following procedure to verify that power has been removed from the system. This
step is required when removing or installing non hot-swap components or when replacing a
non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has fully shut down, disconnect the AC power cord(s) from the power
strip or outlet. (If your system has more than one power supply, remove the AC power
cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).
3.2 Accessing the System
The chassis cover must be removed when performing some prodecures in this chapter.
1. Power down the system.
2. Grasp the two handles on either side and pull the unit straight out until it locks (you will
hear a "click").
3. Remove the three screws and the one thumbscrew securing the top cover to the
chassis.
4. Slide the cover back toward the rear of the chassis then lift the cover upwards and off of
the chassis.
Warning
: Except for short periods of time, do not operate the server without the cover in place.
The chassis cover must be in place to allow for proper airflow and to prevent overheating.
