48
SuperServer 1019D-(12C/14C/16C-)FRN5TP User's Manual
Manufacturing Mode Select
Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings.
Manufacturing Mode
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Normal (Default)
Pins 2-3
Manufacturing Mode
I
2
C Bus for VRM
Jumper JVRM1 allows the BMC or the PCH to access CPU and memory VRM controllers.
Refer to the table below for jumper settings. This is reserved for manufacturing use only.
JVRM1
Jumper Settings
Jumper Setting
Definition
Pins 1-2
BMC (Normal)
Pins 2-3
PCH
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for
the application that hangs. Watch Dog must also be enabled in BIOS.
Note:
When Watch Dog is enabled, users need to write their own application software to
disable it.
Watch Dog
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Reset (Default)
Pins 2-3
NMI
Open
Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port using the onboard graphics controller.
The default setting is Enabled.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled (Default)
Pins 2-3
Disabled
