Supermicro SUPERSERVER 1018R-WR, Руководство пользователя

Страница: 7 / 75

1-2 1-3
Chapter 1: Introduction
S
UPER
S
ERVER 1018R-WR User's Manual
1-2 Motherboard Features
The SuperServer 1018R-WR is built around the X10SRW-F, a single processor
motherboard based on the Intel
®
C612 Express chipset. Below are the main features
of the X10SRW-F. (See Figure 1-1 for a block diagram of the chipset.)
Processors
The X10SRW-F supports a single Intel E5-2600/E5-1600 v3/v4 (limited support) Se-
ries processor in an LGA2011 socket (Socket R3). Please refer to the motherboard
description pages on our website for a complete listing of supported processors
(www.supermicro.com).
Memory
The X10SRW-F has eight DIMM slots that can support up to 1 TB of ECC
3DS LRDIMM, 512 GB of ECC LRDIMM or 256 GB of ECC RDIMM DDR4-
2400/2133/1866/1600 memory. See Chapter 5 for details.
PCIe Expansion Slots
Two riser cards (RSC-R1UW-2E16 and RSC-R1UW-E8R) provided in the server
can support two PCI-E x16 cards and one PCI-E x8 card, respectively. See Chapter
5 Section 6 for details.
Serial ATA
A SATA controller is integrated into the chipset to provide ten SATA 3.0 (6/Gbps)
ports, which are RAID 0, 1, 5 and 10 supported. The SATA drives are hot-swappable
units.
Note:
two SATA DOM ports are also included on the motherboard.
Rear I/O Ports
Ports on the I/O backplane include a COM port, a VGA port, two USB 3.0 ports,
two USB 2.0 ports, two gigabit Ethernet ports and one dedicated IPMI port. A UID
(Unit Identifier) button and LED are also included beside the VGA port..
1-3 Server Chassis Features
The 1018R-WR is built upon the SC514-R407W chassis. Details on the chassis
and on servicing procedures can be found in Chapter 6. The following is a general
outline of the main features of the chassis.
System Power
The SC514-R407W features a redundant 400W power supply consisting of two
power modules. The system does not need to be shut down when replacing or
removing a single power supply module.
Hard Drive Subsystem
The SC514-R407W chassis has an internal hard drive bracket to mount one or
two 2.5" hard drives.
Front Control Panel
The control panel provides a system monitoring and control interface. LEDs indicate
system power, HDD activity, network activity, and a system overheat/fan-fail/UID
LED. A main power button and a system reset button are also included.
Cooling System
The chassis has an innovative cooling design that features four sets of 4-cm
counter-rotating fans located at the front of the chassis. Fan speed control allows
chassis fan speed to be determined by system temperature as determined by IPMI.