Supermicro Supero 6037R-E1R16N, Руководство пользователя

Страница: 51 / 75

Chapter 6: Advanced Chassis Setup
6-9 6-8
S
UPER
S
TORAGE
S
YSTEM 6037R-E1R16N User's Manual
6-5 Power Supply
The SuperServer 6037R-E1R16N has an 920 watt redundant, hot-plug power supply
consisting of two power modules. Each power supply module has an auto-switching
capability, which enables it to automatically sense and operate at a 100V - 240V
input voltage.
Power Supply Failure
If either of the two power supply modules fail, the other will take the full load and
allow the system to continue operation without interruption. The Power Fail LED will
illuminate and remain on until the failed module has been replaced. Replacements
can be ordered directly from Supermicro (see contact information in the Preface).
The power supply modules have a hot-swap capability, meaning you can replace
the failed module without powering down the system.
Removing/Replacing the Power Supply
You do not need to shut down the system to replace a power supply module. The
backup power supply module will keep the system up and running while you replace
the failed hot-swap module. Replace with the same model (see part number in Ap-
pendix B), which can be ordered directly from Supermicro.
1. First unplug the power cord from the failed power supply module.
2. Depress the locking tab on the power supply module and use the handle to
pull it straight out of the chassis.
3. Replace the failed module with another by simply pushing the new power
supply module into the power bay until you hear a click.
4. Secure the locking tab on the unit and finish by plugging the AC power cord
back into the module. See Figure 6-6.
DVD-ROM Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM.
The 6037R-E1R16N accomodates only slim type DVD-ROM drives. Side mounting
brakets are typically needed to mount a slim DVD-ROM drive in the 6037R-E1R16N
server.
First, release the retention screws that secure the server unit to the rack. Grasp the
two handles on either side and pull the unit straight out until it locks (you will hear a
"click"). Next, depress the two buttons on the top of the chassis to release the top
cover and at the same time, push the cover away from you until it stops. You can
then lift the top cover from the chassis to gain full access to the inside of the server.
You must power down the system before installing or removing a DVD-ROM drive.
Drives mount on rails and should "click" into place to be correctly and fully installed
in their bays.
A color mark on a cable typically designates the location of pin 1.