Supermicro SuperBlade SBA-4119SG, Руководство пользователя

Страница: 51 / 76

51
Appendix A BIOS POST Codes
Appendix A
BIOS POST Codes
A.1 BIOS POST Messages
During the Power-On Self-Test (POST), the BIOS will check for problems. If a problem is
found, the BIOS will activate an alarm or display a message. The following is a list of such
BIOS messages.
BIOS POST Messages
BIOS Message Description
Failure Fixed Disk
Fixed disk is not working or not configured properly. Check to see if fixed disk
is attached properly. Run Setup. Find out if the fixed-disk type is correctly
identified.
Stuck key Stuck key on keyboard.
Keyboard error Keyboard not working.
Keyboard Controller Failed Keyboard controller failed test. May require replacing keyboard controller.
Keyboard locked - Unlock key
switch
Unlock the system to proceed.
Monitor type does not match
CMOS - Run SETUP
Monitor type not correctly identified in Setup
Shadow Ram Failed at offset:
nnnn
Shadow RAM failed at offset nnnn of the 64k block at which the error was
detected.
System RAM Failed at offset:
nnnn
System RAM failed at offset nnnn of in the 64k block at which the error was
detected.
Extended RAM Failed at offset:
nnnn
Extended memory not working or not configured properly at offset nnnn.
System battery is dead -
Replace and run SETUP
The CMOS clock battery indicator shows the battery is dead. Replace the
battery and run Setup to reconfigure the system.
System CMOS checksum bad -
Default configuration used
System CMOS has been corrupted or modified incorrectly, perhaps by an
application program that changes data stored in CMOS. The BIOS installed
Default Setup Values. If you do not want these values, enter Setup and enter
your own values. If the error persists, check the system battery or contact your
dealer.
System timer error The timer test failed. Requires repair of system board.
Real time clock error Real-Time Clock fails BIOS hardware test. May require board repair.
Check date and time settings
BIOS found date or time out of range and reset the Real-Time Clock. May
require setting legal date (1991-2099).