Supermicro B2SC2-TF, Руководство пользователя, Страница: 51 / 95

Chapter 4: BIOS
51
Wait For "F1" If Error
Use this feature to force the system to wait until the F1 key is pressed if an error occurs. The
options are Disabled and
Enabled
.
INT19 Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this feature
is set to Immediate, the ROM BIOS of the host adaptors will capture Interrupt 19 at boot
up immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this feature is set to Postponed, the ROM BIOS of the host adaptors will not
capture Interrupt 19 immediately and allow the drives attached to these adaptors to function
as bootable devices at boot up. The options are
Immediate
and Postponed.
Re-try Boot
If this item is enabled, the BIOS will automatically reboot the system from a specified boot
device after its initial boot failure. The options are
Disabled
, Legacy Boot, and EFI Boot.

Power Configuration
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or generate NMI based on
jumper settings when it is expired for more than five minutes. The options are Disabled and
Enabled
.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select 4
Seconds Override for the user to power off the system after pressing and holding the power
button for 4 seconds or longer. Select Instant Off to instantly power off the system as soon
as the user presses the power button. The options are 4 Seconds Override and
Instant Off.
DeepSx Power Policies
Use this feature to configure the Advanced Configuration and Power Interface (ACPI) settings
for the system. Enable S4 to use Hibernation mode (Suspend to Disk) so that all data stored
in of the main memory can be saved in a non-volatile memory area such as in a hard drive
and then power down the system. Enable S5 to power off the whole system except the power
supply unit (PSU) and keep the power button alive so that the user can wake up the system
by using an USB keyboard or mouse. The options are
Disabled
and Enabled in S4-S5.
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Stay Off for the system
power to remain off after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Power On,
Stay Off
, and Last State.