Super B11SCG-ZTF/CTF User's Manual
70
Console Redirection Settings
Out-of-Band Mgmt Port
This feature controls which port Emergency Management Services (EMS) is allowed to
remotely manage a Windows server operating system. The options are
COM1
or COM1/
SOL.
Terminal Type
This feature allows the user to select the target terminal emulation type for Console
Redirection. Select VT100 to use the ASCII Character set. Select VT100+ to add color
and function key support. Select ANSI to use the Extended ASCII Character Set. Select
VT-UTF8 to use UTF8 encoding to map Unicode characters into one or more bytes. The
options are ANSI, VT100, VT100+, and
VT-UTF8
.
Bits per second
Use this feature to set the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 57600, and
115200
(bits per second).
Flow Control
Use this feature to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are
None
, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits, Parity and Stop Bits
SATA and RST Configuration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled or
Enabled
.
SATA Mode Selection
This feature controls the SATA mode. The default is
AHCI
.
SATA0~7
Hot Plug
This feature designates the port specified for hot plugging. Set this feature to Enabled for
hotplugging support, which will allow the user to replace a SATA disk drive without shutting
down the system. The options are Disabled or
Enabled
.