Supermicro 7044H-82, Руководство пользователя

Страница: 67 / 124

Chapter 6: Advanced Chassis Setup
6-9
Installing Components in the 5.25" Drive Bays
1. Drive bay configuration
The 7044H-82R/7044H-X8R/7044H-82 has two 5.25" drive bays. Compo-
nents such as an extra floppy drive, IDE hard drives or CD-ROM drives
can be installed into these 5.25" drive bays.
2. Mounting components in the drive bays
First power down the system and then remove the top/left chassis cover
to access the drive components. With the cover off, remove the two or
four screws that secure the drive carrier to the chassis (one side only)
then push the entire empty drive carrier out from the back.
Adding a CD-ROM drive: remove the guide plates (one on each side) from
the empty drive carrier and screw them into both sides of the CD-ROM
drive using the holes provided. Then slide the CD-ROM into the bay and
secure it to the chassis with the drive carrier screws you first removed.
Attach the power and data cables to the drive. Replace the top/left
chassis cover before restoring power to the system.
Adding an IDE or floppy drive: to add one of these drives, install it into
one of the removed empty drive carriers with the printed circuit board
side toward the carrier so that the drive's mounting holes align with those
in the carrier. Secure the drive to the carrier with four screws then slide
the assembly into the bay and secure it to the chassis with the drive
carrier screws you first removed. Attach the power and data cables to
the drive. Replace the top/left chassis cover before restoring power to
the system.
Note: A red wire typically designates the location of pin 1. You should
keep the drive carriers inserted in any unused drive bays to reduce EMI
and noise and to facilitate the airflow inside the chassis.