Supermicro 7044H-82, Руководство пользователя

Страница: 24 / 124

2-8
S
UPER
S
ERVER 7044H-82R/7044H-X8R/7044H-82 User's Manual
2-5 Checking the Serverboard Setup
After setting up the the system, you will need to open the unit to make sure the
serverboard is properly installed and all the connections have been made.
1. Accessing the inside of the system (see Figure 2-5)
[If rack mounted, first release the retention screws that secure the unit
to the rack. Grasp the two handles on either side and pull the unit
straight out until it locks (you will hear a "click").] There are two screws
that secure the cover to the chassis - remove these first. Depress the
button on the top (side if tower) of the chassis to release the cover.
You can then lift the cover from the chassis to gain full access to the
inside of the server.
2. Check the CPUs (processors)
You should have one or two processors already installed into the
serverboard. Each processor should have its own heatsink attached.
See Chapter 5 for instructions on processor installation.
3. CPU clock ratio setting
The CPU speed should be automatically detected. If not, you will need to
set the correct speed with the BIOS Setup utility. See the Frequency
Ratio setting in BIOS (Chapter 7) to set the processor speed.
4. Check the system memory
Your server may have come with system memory already installed. Make
sure all DIMMs are fully seated in their slots. For details on adding
system memory, refer to Chapter 5.
5. Installing add-on cards
If desired, you can install add-on cards to the system. See Chapter 5 for
details on installing PCI add-on cards.
6. Check all cable connections and airflow
Make sure all power and data cables are properly connected and not blocking
the chassis airflow. See Chapter 5 for details on cable connections.