background image

SUPERIOR

®

 B-VENT GAS FIREPLACES  •  MODELS SLBV-35, SLBV-40  •  INSTALLATION INSTRUCTIONS

Packaging .........................................Page  2
Introduction ......................................Page  2
General Information ..........................Page  2
Gas Pressure Requirements ..............Page  4
Orifice Sizes ......................................Page  4
Gas Valve Diagrams ..........................Page  4
Requirements for the Commonwealth  

      of Massachusetts  .......................Page  4
New York City Approval .....................Page  4
Cold Climate Insulation .....................Page  5
Location ............................................Page  5
Vent Termination Clearances:
   Multiple Terminations.....................Page  6
   Gas Vent Rule ................................Page  6
Minimum Clearances to Combustibles:
   Appliance and Vent Clearances ......Page   7
   Hearth Extension ............................Page   7
   Wall Finishes / Surrounds /  

      Mantels .......................................Page   7
Pre-Installation Steps (Remove 

      Glass Enclosure Panel) ...............Page  8
Typical Installation Sequence ............Page  8
Detailed Installation Steps:
Step 1.  Construct Appliance  

 

   Framing ............................Page  8

 

Fireplace and Framing 

 

   Specifications ...................Page  9

Step 2.  Route the Gas Line ..............Page  11
Step 3.  Install Venting System and 

 

   Exterior Termination .........Page  11

Step 4.  Install Field Wiring ..............Page  12
 

Wiring Diagrams .................Page  13

Step 5.  [Optional] Install Outside  

 

  Combustion Air Kit ............Page  14

 

Installation Accessories ......Page  14

Step 6.  Connect the Gas Line ..........Page  15
Step 7.  Verify Appliance  

 

   Operation .........................Page  16

Step 8.  Install Volcanic Stone, Glowing 

 

   Embers, and Logs  ...........Page  17

 

SLBV-35 Log Placement .....Page  18

 

SLBV-40 Log Placement .....Page  19

Step 9.  Install the Glass Enslosure  

 

   Panel  ...............................Page  20

Step 10. Burner Air Shutter  

 

   Adjustments .....................Page  20

Step 11. Perform Spillage Test ..........Page  22
 

Manually-Reset Safety Limit 

 

   Switch ..............................Page  22

Step 12. Install Hood .........................Page  23
Step 13. Finishing Requirements ......Page  23
Step 14. Attach Safety-in-Operation

    Warnings ......................................Page  24
Gas Conversion Kits
 .........................Page  25

PACKAGING

The assembled vented gas fireplace is packaged 

with the following items:
1 - One log set located in firebox area.

2 - One  envelope  containing  the  literature 

package  which  consists  of  the  care  and 

operations  manual,  installation  instruc-

tions,  safety-in-operation  warning  labels 

and  warranty;  envelope  is  located  in  the 

control compartment.

3 - One hood located behind the glass enclo-

sure panel assembly.

4 - One bag of decorative volcanic stone located 

in the lower control compartment.

5 - One bag of glowing embers located in the 

lower control compartment.

INTROdUCTION 

The 

Millivolt

  appliances  have  a  millivolt  gas 

control valve with piezo ignition system. 
The 

Electronic

  appliances  have  a  battery 

backed-up electronic intermittent pilot ignition 

system. No external electrical power is required 

to  operate  these  appliances;  however,  120V 

AC is recommended (see Step 4, “Install Field 

Wiring,” on 

Page 12

).

Use Only These Approved Vent Components:  

These vented gas fireplaces are designed for 

residential applications. They must be installed 

with  approved  Type-B  double-wall  vent  pipe 

systems and a listed vent termination routed 

to the outside atmosphere. Use only the proper 

size listed below.
•  4" B-Vent for 35" models and 5" B-Vent  for 

40" models.

GENERAL INfORMATION

Children and adults should be alerted to 

the hazards of high surface temperature 

and should stay away to avoid burns or 

clothing ignition. 

Les  enfants  et  les  adultes  devraient 

être infor-més des dangers que posent 

les températures de surface élevées 

et se tenir à distance afin d’éviter des 

brûlures  ou  que  leurs  vêtements  ne 

s’enflamment.

dO NOT ATTEMPT TO ALTER OR 

MOdIfY THE CONSTRUCTION Of THE 

APPLIANCE OR ITS COMPONENTS. ANY 

MOdIfICATION OR ALTERATION MAY 

VOId THE WARRANTY, CERTIfICATION, 

ANd LISTINGS Of THIS UNIT.

       WARNING 

Young children should be care-

fully supervised when they are 

in the same room as the appli-

ance. Toddlers, young children 

and others may be susceptible 

to accidental contact burns.  

A physical barrier is recom-

mended if there are at risk 

individuals in the house.  To 

restrict access to a fireplace 

or stove, install an adjustable 

safety gate to keep toddlers, 

young children and other at 

risk individuals out of the room 

and away from hot surfaces.

       AVERTISSEMENT 

Les jeunes enfants devraient être 

surveillés étroitement lorsqu’ils 

se trouvent dans la même pièce 

que l’appareil. Les tout petits, 

les jeunes enfants ou les adultes 

peuvent subir des brûlures s’ils 

viennent en contact avec la sur-

face chaude.  Il est recommandé 

d’installer une barrière physique 

si des personnes à risques habi-

tent la maison. Pour empêcher 

l’accès à un foyer ou à un poêle, 

installez une barrière de sécu-

rité; cette mesure empêchera les 

tout petits, les jeunes enfants et 

toute  autre  personne  à  risque 

d’avoir accès à la pièce et aux 

surfaces chaudes.

       WARNING 

B-Vent appliances are 

not designed to operate 

in negatively pressured 

environments (pressure within 

the home is less than pressures 

outside). Significant negatively 

pressured environments caused 

by weather, home design, or 

other devices may impact the 

operation of these appliances. 

Negative pressures may result 

in poor flame appearance, 

sooting, damage to property 

and/or severe personal 

injury. do not operate these 

appliances in negatively 

pressured environments.

TABLE Of CONTENTS 

2

Содержание SLBV-35





























Отзывы: