SuperiorFireplaces.us.com
900463-01A
22
EMBER PLACEMENT
INSTALLATION
Continued
Figure 34 - Placement of Glowing Embers (shown with Platinum Bright Embers)
Figure 33 - Platinum Bright Embers
Glowing Embers (rockwool)
Flat Front Burner
Ember Material
WARNING: Do not use any other
ember material not supplied with
this unit.
WARNING: Do not operate unit
without ember material correctly in
place as shown in Figures 33 and
34. Do NOT place ember material
anywhere else on the unit. Use only
ember material supplied with unit.
Excessive or incorrectly placed ember
material may produce carbon monox-
ide or soot. If replacement embers
are needed, the replacement em-
bers must be purchased from IHP.
See Page 40 for part numbers.
VOLCANIC STONE PLACEMENT
• Glowing Embers placement.
Place
glowing embers material on front flat
burner in areas away from ports as shown
in
Figure 34
.
•
Add Volcanic Stone; Volcanic Stone may
cover 1/2 inch of the front burner(flat
metal ember pan burner) but shall not
be allowed to come in contact with either
the burner ports or fl ame around base of
appliance if desired.
DO NOT place rock
or additional logs on front burner or on
logs except as directed above.
Placing
any material on unit other than ember
material on front burner may result in
production of carbon monoxide or soot.
A switch log is included with each log set.
This log is designed to house a switch on
remote ready models. On variable remote
models, this switch is not needed. The log
can be placed on the fl oor of the fi replace
to enhance the look of the log set. Use
Volcanic Stone to hide wires from switch/
log to control valve. Place switch/log so
the switch is easy to access.
Two ember materials are supplied with this
log set. Platinum Bright Embers give a bright
glow appearing as hot coals. Should embers
need replacing, see
Accessories
,
Page 41
.
•
Platinum Bright Ember placement.
Add embers to front, fl at burner. Gently
remove embers from bag. Separate
pieces of ember material and place on
surface of fl at burner just behind hori-
zontal ports as shown in
Figure 33
.
WARNING: All previously ap-
plied loose material must be re-
moved prior to reapplication.
