SuperiorFireplaces.us.com
900463-01A
24
REMOTE READY MODELS OPERATION
Continued
NOTE: AUTO is only functional when
using GWMT1 or GWMS2 optional ac-
cessories. If hand-held remote control is
installed but not being used, slide remote
selector switch to ON (It must be in this
position for burners to light. Switch will be
in REMOTE position if using hand-held
remote).
11. Set fl ame adjustment knob to any level
between HI and LO.
12. To leave pilot lit an shut off burners only:
turn control knob clockwise
to the
PILOT position, or use remote control
manual OFF button , or set selector switch
in the OFF position.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: Make sure the
remote selector switch is in the
OFF position when you are away
from home for long periods of
time. Appliance will come on au-
tomatically with selector switch
in the ON position.
Figure 36 - Pilot (Natural)
Igniter
Electrode
Pilot Burner
6. Press in and turn control knob counter-
clockwise
to the PILOT position.
Press in control knob for fi ve (5) seconds
(see Figure 35)
.
NOTE: You may be running this appliance
for the fi rst time after hooking up to gas
supply. If so, the control knob may need
to be pressed in for 30 seconds or more.
This will allow air to bleed from the gas
system.
7. With control knob pressed in, press and
release igniter button on left side of log set.
This will light pilot. The pilot is attached to
the front of U-shaped burner. If needed,
keep pressing igniter button until pilot
lights.
NOTE: If pilot does not stay lit, contact a
qualifi ed service person or gas supplier for
repairs. Until repairs are made, light pilot
with match. To light pilot with match, see
Manual Lighting Procedure, Page 25.
8. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop out when
released, contact a qualified service
person or gas supplier for repairs.
NOTE: If pilot goes out, repeat steps 4
through 8.
9. Slightly push in and turn control knob coun-
terclockwise
to the ON position. If
using a hand-held remote control acces-
sory, go to
Optional Hand-Held Remote
Operation
on
Page 25
.
10. Wait one minute and put switch in ON
position to light burners.
AUTO
OFF
ON
Figure 35 - Control Knob, Igniter Button
and AUTO/OFF/ON Switch
Selector Switch
Control Knob in
OFF Position
Flame
Adjustment
Knob
Igniter
