SuperiorFireplaces.us.com
901008-00_NC
16
NOTE:
A Mosaic Masonry panel kit is required for use with your
WRE6036, WRE6042, or WRE6050 Firebox. (Not supplied, see page
24 for models available).
MOSAIC MASONRY BRICK INSTALLATION
IMPORTANT: Installation of brick panels should be
done after the fireplace is placed in a permanent
location.
Note:
Remove grate, screen assemblies and all hardware components
out of the box prior to installation.
INSTALLATION
1. Install bottom brick panel. Using at least two people, hold bot-
tom brick panel by its side edges. Place the back edge of bottom
panel into the firebox first and carefully lower the front edge of
panel. Make sure bottom panel is centered in the firebox and
flush with the front of the fireplace. Be careful not to pinch your
fingers between the panel and firebox (Figure 31).
2. Install the left and right side leading bricks (Figure 31).
WARNING
LIFTING HAZARD
SINGLE -PERSON LIFT COULD
CAUSE INJURY.
USE ASSISTANCE WHEN MOVING
OR LIFTING.
Figure 31 - Installing Hearth and Leading Brick panels
Hearth Panel
Side leading
brick Panel
4. Secure the firebrick wall using 2 of the retainers provided. The
bracket will slip underneath the metal lip on the top of the wall
and screw into the inner dome of the fireplace (Figure 33).
Figure 32 - Slots for Firebrick Walls
Figure 33 - Installing Side Walls
Retaining
Bracket
Leading
Brick
Right Wall
5. Install the rear firebrick wall last. Place the wall face side down
on the hearth with the bottom of the wall toward the rear of the
firebox and the top toward the front of the fireplace. Tilt the wall
up toward the back of the firebox. Secure with 2 rear retaining
brackets provided (Figure 34, page 17).
6. It is recommended that the joints between all firebrick walls
be grouted for a more finished look, see grouting instruc-
tions. For more information and to watch a how to video go
to
SuperiorFireplaces.us.com
and select Technical Support.
MOSAIC MASONRY BRICK PANELS INSTALLATION
3. Install the left and right firebrick walls. There is a bracket with 2
tabs on the bottom of each firebrick wall. Angle the wall into the
fireplace opening and into the slots on the side of the hearth (Fig-
ure 32), then tilt the top of the panel toward the firebox surround.
Slot
Right Face
Hearth
