Superior DRI3030TENC, Инструкция по установке и эксплуатации, Страница: 23 / 38

23
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
AUTO
ON
PILOT
BURNER
TOTAL
COMFO
RT
CONTR
OL
OPERATION
Remote Control System
The Remote and Receiver allows you to command the functions of your
appliance from the comfort of your chair and is configured to control
the On/Off primary burner operation, its flame levels (through six levels)
and provides On/Off and Smart thermostatic control of the appliance.
The system controls blower speed through six (6) levels and has a
constantly powered 120V/60Hz power outlet.
The Receiver connects directly to the gas valve, stepper motor and the
Blower Control Module with and umbilical cord wiring harness (see Wire
Diagram on Page 26 ) .
The Receiver accepts commands via radio frequency from the Remote
(transmitter) and does not require line-of-sight operation.
The Receiver three position slider switch can be set to one of three posi-
tions: ON (Manual Override), REMOTE (Remote Control) or OFF.
Initializing The System For The First Time
Install 4 AA batteries into the receiver battery bay (behind the switch
plate). Note the polarity of the battery and insert into the battery bay as
indicated on the Battery cover (+/-).
Place the 3 position slider switch in the "Remote" position (see Figure
21 ) . Using the end of a paper clip, or other similar object, insert the
end of the paper clip into the hole marked "PRG" on the Receiver front
cover. The Receiver will "beep" three (3) times to indicate that it is ready
to synchronize with the Remote (transmitter).
Install 3 AAA type batteries in the Remote (transmitter) battery bay,
located on the base of the Remote. With the batteries already installed
in the Remote, push the ON button. The Receiver will “beep” four times
to indicate the Remote’s command is accepted and sets to the particular
code of that Remote. The system is now initialized.
Low Battery Power Detection
The life span of the Receiver batteries depends on various factors: quality
of the batteries used, the number of ignitions of the appliance, the number
of changes to the room thermostat set point, etc.
When the Receiver batteries are low, two “beeps” will be emitted from
the Receiver when it receives an ON/OFF command from the Remote.
This is an alert for a low battery condition for the Receiver. When the
batteries are replaced the “beep” will be emitted from the Receiver when
the ON/OFF key is pressed (See Initializing The System).
Figure 21 - Control Compartment
ON REMOTE OFF
PRG
WARNING
Fire hazard. Can cause severe injury or death.
The receiver causes ignition of the appliance. The
appliance can turn on suddenly. Keep away from
the appliance burner when operating the remote
system or activating manual bypass of the remote
system.
CAUTION
Property damage hazard. Excessive heat can cause
property damage. The appliance can stay lit for many
hours. Turn off the appliance if it is not going to be
attended for any length of time. Always place the
Transmitter where children can not reach it.
Figure 22 - Remote (transmitter)
Receiver
ON / AUTO
Pilot
ON/OFF Key
THERMOSTAT Key
UP/DOWN Arrow Key
MODE Key
Blue LCD Display