www.SuperiorFireplaces.US.com
126861-01A
21
OPERATION
Continued
ON
Figure 32 - Low Battery Display
Low Battery - Remote Receiver
When batteries in receiver are low, no "beep"
will be admitted from the receiver when ON/
OFF button is pressed. This is an alert for a
low battery condition for the receiver. When
the batteries are replaced the "beep" will be
emitted from the receiver when the ON/OFF
button is pressed.
FAHRENHEIT/CELSIUS INDICATOR
You can set your remote control to display the
temperature in either Fahrenheit or Celsius.
With remote control off, press Thermostat
button and Mode button at the same time.
This will toggle the display from °F to °C (See
Figure 33).
Figure 33 - Remote Control Display of
Fahrenheit/Celsius
MINIMUM
MAXIMUM
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
TO TURN OFF GAS
TO APPLIANCE
1. Turn off safety shutoff switch.
2. Turn off all electric power to appliance if
service is to be performed.
3. Remove center brick/control cover.
4. Turn equipment shutoff valve clockwise
to OFF. Do not force.
5. Replace access cover.
MANUAL LIGHTING
PROCEDURE
1. Set the switch on the remote receiver to
the ON position.
2. Turn pilot switch to the ON position.
HAND-HELD
REMOTE OPERATION
BATTERIES
WARNING: Make sure your
selector switch is in OFF posi-
tion before installing or chang-
ing batteries in your hand-held
remote or receiver.
For installing or replacing batteries in remote
control or receiver, see
Installing Batteries in
Remote Control and Receiver
on page 19.
Low Battery - Hand-Held Remote Control
When batteries in hand-held remote control
are low, an icon will appear on display (see
Figure 32).
OPERATING REMOTE CONTROL
WARNING: Fireplace can
turn on suddenly. Keep away
from burner.
When any button is pushed on remote control,
the LCD display will glow blue. The blue glow
will go off after several seconds if no action is
being taken with remote.
ON/OFF
Push ON/OFF button and burners will come
on in high position (see Figure 34, page
22). A beep from the receiver confirms the
command.
Push ON/OFF button again and burners will
turn off. A beep from the receiver confirms
the command.
