www.SuperiorFireplaces.US.com
126861-01A
19
Figure 29 - Battery Install Remote
Control Receiver
Battery Housing
Cover
Cover Plate
Screws
Receiver
INSTALLATION
Continued
Installing Battery into Remote Receiver
1. Remove screws from cover plate.
2. Remove battery housing cover.
3. Install 4 AA batteries.
5. Replace battery housing cover.
6. Replace cover plate.
Installing Cover Plate Onto Remote Receiver
1. Locate and remove cover plate from
packaging.
2. Make sure sliding selector switch fits over
switch on receiver.
3. Attach cover plate to receiver with 2
screws as shown in Figure 29.
4. See page 23 for instructions on program-
ming remote receiver to hand-held remote
control if needed.
Note: For hand-held remote control to
work, programming (synchronizing) re-
mote to receiver must be completed.
Figure 28 - Remote Receiver (Face
Bottom not shown for Clarity)
Backup
Battery
Remote
Receiver
GLASS PEBBLE INSTALLATION
WARNING: Do not change
or substitute glass pebbles
provided with this fireplace. If
replacing, use only replacement
glass pebbles. See
Replacement
Parts
page 30.
Clear glass pebbles are included with your
fireplace.
1. Place glass pebbles in a single layer
evenly on the pebble pan. Make sure not
to place any on the burner in the center
of the pebble pan.
GLASS PANEL INSTALLATION
The glass panel assembly should be installed
after the fireplace is completely framed and
finished. The brackets are attached to the front
side face of the fireplace using two screws as
shown in Figure 30. Position the glass panel
in the bracket so that it is securely in place.
Glass Panel
Bracket
Screws
Figure 30 - Installing Glass Panel
