49
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900299-00, 05/2016
Innovative Hearth Products
DRT40 Multi-View Series Direct-Vent Gas Fireplace
Front Glass Enclosure Panel, Removal
and Installation
WARNING
Any safety screen, guard, or
barrier removed for servicing
an appliance must be replaced
prior to operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
WARNING
•
Do not attempt to substitute
the materials used on this
door, or replace cracked or
broken glass.
•
Handle this glass with ex-
treme care! Glass is sus-
ceptible to damage – Do not
scratch or handle roughly
while reinstalling the glass
door frame.
•
The glass door(s) of this
appliance must only be re-
placed as a complete unit
as provided by the manu-
facturer. Do not attempt to
replace broken, cracked or
chipped glass separately.
•
Do not attempt to touch the
front enclosure glass with
your hands while the fire-
place is in use.
•
DO NOT abuse glass door by
striking or slamming shut.
WARNING
Do not operate appliance with the
glass front removed, cracked, or
broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panels are installed. Generally the
front glass enclosure panel should not be re-
moved except to gain access to the components
within the firebox.
Removing Glass Enclosure Panels
(see
Figure 76
)
To access the glass door securing latches, first
remove the hood by pulling firmly straight away
from the unit. Remove the front face assembly
by lifting top and bottom evenly and pulling
straight out from the unit once the brackets
are disengaged.
Locate the two (2) latches at the top of the
control compartment and disengage them from
the door frame bottom vee-flange, pulling down
on their handles to open them.
Retrieve the glass door. Visually inspect the
gasket on the backside of the frame. Gasket
surface must be clean, free of irregularities
and seated firmly.
Position the door in front of the firebox opening
with the bottom of the door held away from the
fireplace
(Figure 76)
. Hook the top flange of the
door frame over the top of the firebox frame.
Let the bottom of the door frame swing gently
in towards the fireplace ensuring that the gasket
seats evenly as the door frame draws shut.
Fasten the two latches located underneath the
firebox floor to the door's vee-flange. Close
both the latches securely.
NOTE: Front Face Assembly with
barrier installed must be rein-
stalled prior to operation.
Figure 76
SEE THROUGH SHOWN
Glass Door Latch
Control Compartment Access Panel and Hinge
Front Glass
Enclosure Panel
Firebox Floor
Bottom Vee-flange
Glass Door Frame
Top Flange
Glass Door Frame
WARNING
The door should easily close
without needing to be pressed
down. If it has to be pressed
down to close, the gasket in the
top of the door should be dressed
so it lays on the glass.
