6Superabrasive
User Manual Original Language
Lavina® 20GE
7/2020
22
4.6 USE HORIZONTAL PROPANE TANK
The standard Lavina 20GE is equipped with vertical propane tank with vapor draw
. If necessary the machine can work
with horizontal tank but obligatory with vapor draw. Here is how to readjust the machine for horizontal propane tank:
Dismount the support that carries the strap holding the tank. Dismount the strap from the support. Dismount the rear
support of the tank. Remove half of the rubber insulator of the support. Place the strap in the middle of the tank
support and place again the half of the rubber insulator. This support together with the strap should be mounted on
the upper level.
Dismount the front tank support and mount it on the upper level.
Dismount the right support that has the tensioning key of the tank strap.
Mount the key on the carriage using the plate underneath and the available screws and nuts. Adjust the locking
depending on the diameter of the propane tank.
While working do not forget that you should use properly fitted tank with vapor draw, to avoid freeze regulator
problems.
4.7 CONTROL BOARD
1.
Throttle -
Push forward to accelerate.
2.
Start/Stop clutch - Start
will electronically activate the grinding plates to
spin;
Stop
will disconnect engine from grinding heads.
3.
Water pump switch.
4.
Lights switch.
5.
Start/Stop Engine switch -
Turn key fully to the right (make contact) to
ignite the engine. Fully to the left will arrest the engine
.
6.
Electronics Module of digital fuel control system -
When running, it
indicates the revolutions per minute of the tool holders. When not
running, it indicates the worked hours. The hour meter will blink
between 48-52 hours as a reminder for oil change.
7.
Emergency button
used to stop the motor in case of emergency.
8.
Panel cover -
under the cover is the
30 Amp fuse for the electrical
system and the contacts separating the electrical system between
carriage and the main head.
9.
USB charger.
10.
Phone holder.
11.
Cover with cup holder.
4.8 STARTING THE MACHINE
First, follow the directions in the chapter on Safety Devices and Safety Instructions. Check oil level. Open the service valve on
the propane tank about one and a half (counterclockwise) turns. Next, make sure the Start/Stop Clutch rocker (2) is in stop
position and check that the throttle (3) in the IDLE position. This creates the necessary vacuum to open the lock‐off valve inside
the regulator. Actuation of the throttle lever will keep the lock‐off valve from opening and the engine from getting fuel so the
engine will not start. Proper maintenance will insure easy starting. Engage starter (1) for a
MAXIMUM
of 5 to 6 seconds or until
the engine fires. Serious starter damage will result if this is exceeded and the warranty may not apply. Operate the engine at
half throttle for approximately two minutes to properly warm engine. Then advance to full throttle for best results. If working
wet, add water to the floor surface. If working dry, instead switch on the vacuum unit. Finally, hold the machine firmly and push
the start of the Start/Stop clutch button (2).
Fgure 4.4
Figure 4.10
