Superabrasive Lavina 21 Series, Руководство пользователя, Страница: 9 / 34

Superabrasive Owner’s Manual – Lavina 21 1/2013
9
MOUNTING TOOLS
The machine should be not connected to electricity when changing the tools.
To change tools flip the carriage over to the floor. Ensure first if the handle (Fig. 4.2) or the column (Fig. 4.3) is in the
upright position.
Figure 4.2 Figure 4.3
Mount the tools only after ensuring that there is enough diamond bond material left. Be sure that the plates are always
clean before mounting.
PLUG AND CABLE
A plug (min. 16A; 220V, IP55) should be attached to the cable, recommended H07BQ-F3x2,5mm² with maximum
length 20 meters, according to the standards of the country where the machine will work. The yellow/green cable is
ground.
The plug should be attached by a technician.
CONTROL BOARD
1.
Working hours meter
counts the hours which the machine has worked
2.
Emergency/stop button
stops motor or used in Emergency situations
3.
ON button-Power led
starts the motor, lights green when power on
STARTING THE MACHINE
Follow the directions in chapter Safety Devices and Safety Instructions. Next, pull the emergency button (2) to ensure
that the machine is in working condition. If working wet, add water to the floor surface. If working dry, omit this step, and
instead, switch on the vacuum unit. Finally, hold the machine firmly and push the start button (3)
OPERATING THE MACHINE
Guide the machine in straight lines across the floor, and with each new line overlap a little bit of the previously
completed surface. Work at a constant speed allowing the tools time to work at a speed appropriate for the tools’ grit
size. Avoid vibrations. Do not stop the Lavina 21 machine in one spot while the tools are still working because they will
leave marks on the floor surface. When working wet, open the water tank periodically to release water onto the floor
surface. When working dry, check the floor surface periodically to ensure that dust is not accumulating on the surface,
also check regularly if your vacuum works properly.
STOPPING THE MACHINE
The stopping of the machine must be done gradually until the motor stops. Do not stop moving the machine before
arresting the motor as the tools could damage the surface. To stop push the emergency/stop button (3).
Remember not to hold the machine in one spot before turning off the motor.
Figure 4.4