Super Handy GUT099, Руководство пользователя

Страница: 15 / 20

14
ANGLE ADJUSTMENT
To adjust the Trimmer angle, press both sides of the
Rotational Button (24), adjust the Hedge Trimmer
Blade (25) to the desired position and release
until it clicks into place.
ADDING CHAIN BAR AND CHAIN LUBRICANT
The pole chain saw is equipped with an oil automatic system. Chain bar and Chain must
always be oil lubricated when working. Non-observance of this will result in increased wear out
on the bar and saw chain.
NOTE : Pole chain saw comes from the factory with no chain oil added. Lubricant oil level
should also be checked after every 10 minutes of use and refilled as needed.
1. Remove oil tank cover.
2. Carefully pour the bar and chain Lubricant oil into the tank.
3. Wipe off excess oil.
4. Check and fill the oil tank when quick view oil indicator is below the MAX indicator line.
5. Repeat as needed.
NOTE : It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute. When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly lubricated; this will prevent rust on the
chain and bar sprocket.
STARTING AND STOPPING
• Wear non-slip gloves for maximum grip and protection.
• Maintain a proper grip on the unit whenever the motor is running. Use your right hand to firmly
grip the rear handle while your left hand has a firm grip on the pole shaft.
• Hold unit firmly with both hands. Always keep your left hand on the pole shaft and your right
hand on the rear handle, so your body is to the left of the chain line. Never use a left-handed
grip, or any stance that places your body or arm across the chain line.
• Never stand directly under the limb you are cutting.
• Be certain the trigger (8 &9) is fully tightened before operating equipment; check them
periodically for tightness during use to avoid serious injury.
• Remove the scabbard (25) from the blade before operation. To turn on the machine, you
should first push the switch lock button (4) and then press the switch handle(3). Release the
switch-handle will make the machine stop.
MAINTENANCE (pole chain saw)
When servicing, use only identical replacement parts. Use of any other parts may create
a hazard or cause product damage.
Always wear safety goggles or safety glasses with side shields during power tool
operation or when blowing dust.
Before inspecting, cleaning or servicing the unit, stop the motor, wait for all moving
parts to stop, and disconnect the battery pack. Failure to follow these instructions can
result in serious personal injury or property damage.