CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015
37
Revision 05
In Figure 3- 2, “
10
10
10
10
” points to the
STATUS
STATUS
STATUS
STATUS
indicator on the front panel of the AU. Table 4 lists the indicator’s behaviors
and their meaning.
Table
Table
Table
Table 4
444
STATUS
STATUS
STATUS
STATUS Indicator
Indicator
Indicator
Indicator
STATUS
STATUS
STATUS
STATUS
Description
Description
Description
Description
Flashes green
Device runs Normally
Turns green and stays lit
Software has crashed, but it can reboot automatically in 3mins
Flashes red
Device alarms, need check
Turns red and stays lit
Software has crashed, but it can reboot automatically in 3mins
Flashes yellow
Program is upgrading
Turns yellow and stays lit
Device is starting
3.6.
3.6.
3.6.
3.6. Master
Master
Master
Master //// Slave
Slave
Slave
Slave AU
AU
AU
AU Selection
Selection
Selection
Selection
Each AU is factory-set to be the Master AU. See Figure 3- 6 and the procedure below to set or change an AU to
Master or Slave.
To change an AU to Slave:
1. Power on the AU which will be set to be the Slave AU.
Note:
The selected AU cannot be connected to the CrossFire system prior to being set to Slave.
2. Log in to the AU WebOMT. See Section 2 for the procedures to access the OMT.
3. Select the
Engineering
Engineering
Engineering
Engineering
tab.
4. In the
Advanced
Advanced
Advanced
Advanced Command
Command
Command
Command
area, click the drop-down menu for the
Master-slave
Master-slave
Master-slave
Master-slave AU
AU
AU
AU select
select
select
select
command and select
Slave
Slave
Slave
Slave AU
AU
AU
AU
from the drop-down menu.
5. Click
Set
Set
Set
Set
in the pop-up window.
