SRC-7000 User’s Manual
70
Appendix C
Troubleshooting Tables
Problem Solution
LCD does not show
anything when you touch it
•
Batteries may be dead.
•
Replace the batteries with three new AAA Alkaline batteries.
•
Check the batteries are properly installed.
The SRC-7000 doesn’t
operate a device.
•
Make sure that the desired device on the SRC-7000 LCD panel
has been selected.
•
Move closer to the device. The maximum operating distance
is approximately 10 meters (30 feet).
•
Ensure that you are aiming the SRC-7000 directly at the device
and that there are no obstructions between the SRC-7000 and
the device.
•
Ensure that you have correctly used the learning function to
configure the device or the Pre-Programmed Code has been
properly done.
•
Re-teach the malfunction key.
You cannot operate a
device even after teaching
the device using the
learning function.
•
Make sure that your SRC-7000 has correctly learning the target
device’s remote control code.
•
Delete the device data from the SRC-7000 and carry out the
learning function again.
•
Make sure you did not program more than one remote for a
given device.
You see an “error” display
on the LCD screen during
the learning procedure.
•
Make sure you hold the target remote’s key till the screen
displays OK or Error on the screen.
•
Make sure the two remotes are not too close or too far apart –
keep them about 2~4 inches (5~10 cm) apart, and your device
remote control is aiming directly at the SRC-7000’s learning
eye.
You see an “error” display
during operation.
•
The key that you pressed has not been taught.
•
Teach the key using the learning procedure.
IR LEARNING is not
successful.
•
Replace batteries in the SRC-7000 and the remote you are
trying to configure.
•
Keep the distance between the remote control and the
SRC-7000’s learning eye to about 2~4 inches.
•
Do not use the learn function near an incandescent lamp.
•
Memory capacity is full (56 keys for each of eight models).
•
The learning process has no errors, but you still can’t control
your AV devices:
-
Repeat the learning procedure again.
