SRC-7000 User’s Manual
18
2.3 Device setting
1.
Turn on the targeted device for SRC-7000 to setting the device.
2.
SRC-7000 will directly get throw the setup mode when you operate
the SRC-7000 at first time. Please tap the target device key in the
Main Menu to enter “Setup device” menu. (ex. “TV” device)
* Pre-code:
load pre-programmed IR code from the factory
default (no guarantee being able to control all brand
devices).
3.
Pressing the
or
buttons to choose “Yes” item and
press
button for entering the operation mode.
4.
Choose the first letter of targeted device brand (ex.
n
“S” on
behalf of Sony, Samsung…etc ), and point the SRC-7000 at
the targeted device, and then tap
o
soft button to start
auto searching.
5.
As you see the targeted device has been turned off, please tap
or press any buttons to stop auto searching right away. Tap
or
p
gently to figure out the correct remote code
(code number as shown in the top middle position) till the
targeted device has been turned on again. Press the power
key to test the code to confirm the code.
6.
Finally, press
button to load the code and exit.
