7
COOLING
We recommend starting TRANSFORM early in the morning on warm days to get a cool room..
This TRANSFORM unit has a self-evaporation function for condensation water, so that it is normally not
necessary to empty the water tank in cooling mode. The drainage hose need not be connected. Please
make sure that the outlet is closed with the rubber cap during operation.
(This does not apply in the case of high air humidity. If the TRANSFORM unit operates in cooling mode for a longer period and
especially at a time of year with high air humidity, the condensation tank may be full. The control lamp will remind you to empty the
water. Refer to error message E4. In such a case, empty the water tank via the condensation water outlet. If continuous high air
humidity is likely, it is recommended to drain the condensation continuously via the drainage hose.)
COOLING IN INDOOR OPERATION
The TRANSFORM unit stands in the room to be cooled.
Connect the air hose and the air outlet grid to the TRANSFORM unit as displayed in the illustration; the air
hose connection piece and air outlet grid need to be exchanged.
The warm extract air must be emitted from the room via the air hose. This can be executed e.g. via a tilted
window, a door or wall aperture. Make sure that no warm outside air can enter the room. For effective
cooling, we recommend our selection of various accessories which reduce or prevent entry of warm air into
the room.
Set the function to „COOLING“. Set the target temperature using the temperature control. The settable
temperature range is between 17°C and 30°C target temperature. The TRANSFORM unit must only be
used in an ambient temperature of maximum 32°C.
Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control lamp has flashed for 3
minutes. Cooling effect may require a further 10 minutes. Further information is available under the item, „Troubleshooting“.
COOLING IN OUTDOOR OPERATION
The TRANSFORM unit is outside the room to be cooled.
Connect the air hose and the air outlet grid to the TRANSFORM unit as displayed in the illustration; the air
hose connection piece and air outlet grid need to be exchanged.
Place the TRANSFORM unit in the shade if possible and in a cool place in order to increase efficiency and
to avoid overheating. At an ambient temperature of over 32°C, the TRANSFORM unit may deactivate. If th is
occurs continuously, we recommend you temporarily use the INDOOR OPERATION of the TRANSFORM
unit. We recommend that a drainage hose for condensation water be connected.
Set the function to „COOLING“. The settable temperature range is between 17°C and 30°C. This can be se t
using the temperature control.
The air with high oxygen content cooled by the TRANSFORM unit is led into the room via the air hose. This
can be executed e.g. via a tilted window, a door or wall aperture. Make sure that no warm outside air can
enter the room. We recommend that a drainage hose for condensation water be connected. For effective
Содержание Klimatronic Transform 10500
Страница 1: ...Instruction Manual ...
