Full“) lights up. Please let the water drain through the drain hose and then remove the hose.
Close the rubber blockage of the drainage hole.
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and neutral detergent and then wipe dry
with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks with neutral detergent and lukewarm water, then let it air-dry
before inserting it back into the unit.
Troubleshooting
Problem
Possible causes
Suggestions
1. Unit does not start
when pressing
“POWER”.
Water tank is full and indicating light
“W.F.” is blinking.
Empty the water tank.
Room temperature is lower than the set
temperature during operation mode
cooling.
Reset the temperature.
2. It’s not cool
enough.
Doors or windows are not closed.
Close all doors and windows.
There are heat sources in the room.
Remove the heat sources if possible.
Exhaust hose is not installed or blocked. Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Set temperature is too high.
Reset the temperature.
Air inlet is blocked.
Clean the air inlet
3. Unit is too loud.
The ground is not even and flat enough
Place the unit on an even and flat surface.
The sound comes from the flowing of
the refrigerant inside the unit.
None, this sound is normal.
4. E0 Code
Room temperature sensor is not
functioning.
Let the sensor be replaced by your
vendor. The unit can also work without a
new sensor.
5. E2 Code
Water tank is full.
Empty the water tank.
