Sunsystem SWP 2N 300, Инструкция по установке и эксплуатации, Страница: 4 / 24

4
ТЕХНИЧЕСКИ ПАСПОРТ. ИНСТРУКЦИЯ за МОНТАЖ и ЕКСПЛОАТАЦИЯ ТЕХНИЧЕСКИ ПАСПОРТ. ИНСТРУКЦИЯ за МОНТАЖ и ЕКСПЛОАТАЦИЯ
INSTALLATION and OPERATION MANUAL INSTALLATION and OPERATION MANUAL
protective equipment
i
Use only original SUNSYSTEM
parts.
1.1. Requirements to SWP installation
room
When choosing a room for tank installation
observe the following requirements:
- to have a drainage channel. Some
maintenance procedures require draining
of all water from the tank.
- Thermal insulation of the room. This
provides efficiency of the appliance and
prevents the water from freezing.
1.2. Requirements for installation.
- The length of connecting pipes between
the water tank and consumer must be as
short as possible.
- Before connecting the water tank to the
installation, check all screw connections
(plug and etc.). In very rare cases - during
transportation, loading and unloading
operations - the screw connections may
be loosen.
- Before commissioning, check the
installation for leaks
- Do not exceed the working pressure of 3
bar for buffer tank and 6 bar for hygienic
stainless steel coil.
- If there is a risk of freezing of water in
the tank - drain the tank completely or let
the water tank works continuously.
Dear Customers,
We strongly hope that the appliance
you have bought from us will contribute
to creating comfort at you homes and
decreasing the energy expenditure.
This manual contains important
information for the safe and correct
installation, start-up and trouble-free
operation and maintenance of the water
heater.
The water heater can be used for
producing of domestic hot water (DHW)
only in the manner described in this
manual.
The application and any other was the
area of operation is not recommended by
the manufacturer and is not responsible
for the occurrence of defects or failures.
1. INSTRUCTIONS TO INSTALLER

The preparation, installation
and commissioning must be
performed by an authorized
installer / service.
During installation and operation, the
country specific requirements and
regulations must be observed:
• local construction regulations on
installation of water tank; weight of the
boiler to comply with the stability of the
floor of the room where it will be installed.
• regulations and norms concerning
the fitting of theinstallation with safety
devices.
• safety during installation - personal