ATTENTION
:
Never build an enclosure under the Burner or partition side walls, the
Burner must be Free Hanging supported by the countertop only! Must have clear access to
underside of burner within reach of at least Two Vents.
3. Allow for Ventilation
Your Burner has vent holes around the
parameter of hood, allowing proper airflow
to the burner, also increased airflow into
burner chamber is required through the
underside of Drip-Pan. Because of this you
must allow adequate airflow to burner
underside by alleviating an opening below
drip-pan. Follow the Cut-Out Height of 10
Inches allowing a minimum of
¾”
opening.
1.
Slide Grill in Place
Your Power Burner is specially designed
with an internal built in hanger lip located at
the Right, Left and Back sides. The grill lip
allows it to hang by the three supported
edges on the right, left and back. The front
control panel requires no supporting edge;
it is designed to hang down the front of your
cut-out.
2. Securing in Place
The control panel is designed to sit flush
against the island face. If countertop
extends beyond the islands face wall notch
Out a Cut-Out from each side of Counter
Edge. This way the Burner will rest flush
with the island face wall. If this is not done a
gap will be created exposing the forward
portions of the left and right-side firewalls.
Install & Placement
Your grill is SELF-RIMMING, meaning the lip of grill rests on top of the counter edge around the cut-out
with the front of grill which is Free Hanging from countertop. Because of this, there is No Need for any
Trim-Kit like with many other grills in the market.
BURNER INSTALLATION – INSTALL & PLACEMENT
PAGE 6
Содержание POWER CIRQUE EMCHDZ42
Страница 6: ...BURNER PARTS LIST PARTS DIAGRAM PAGE 2...