Open Area Counter-Top Install
1.
For breezy days, be careful not to leave the cover on for more than 15 minutes, when the burners
are on HIGH Heat. (
Never leave grill unattended when in operation
)
2.
If you suspect the grill is overheating, using an oven mitt, remove the hood. Then turn the burner
control knob to off position.
3.
Orient the grill so the Prevailing winds are not blowing into the rear or side of Burner or erect a
partition wall above the counter height to prevent flame disbursement.
ATTENTION:
All Gas Grill Installations MUST HAVE MINIMUM TWO AIR-FLOW VENTS, either in
ELEVATED POSITION for Natural Gas or LOWERED POSITION for Liquid Propane. Your Warranty may be
VOID if island does not meet basic setup requirements.
BURNER INSTALLATION – OPEN AREA
PAGE 7
1.
Countertop Slide-in Installation
(A) Burner Cut-out Width---------------------------------------------------------- 22-3/4” Min. Width
(B) Burner Cut-out Height--------------------------------------------------------- 10” Min. Height
(C) Burner Cut-out Depth---------------------------------------------------------- 22-1/2” Min. Depth
(D) Must have TWO Vents in HIGH position for Natural Gas
(E) Must have TWO Vents in LOW position for Liquid Propane
(F) Properly stow-away the Liquid Propane Tank
(G) Leave Minimum ¾” Gap below Drip Pan for Air/Gas Ventilation
(H) Pot-Filler Notch out, see page 4 for more details
Содержание POWER CIRQUE EMCHDZ42
Страница 6: ...BURNER PARTS LIST PARTS DIAGRAM PAGE 2...