-5-
SPECIFICATIONS
Model SC10T-1-NG
Model SC10T-1-LP
BTU/HR Input
Type Gas
Ignition Type
Temp. Control
Weight
Heater
Shipping
Inlet Gas Pressure
Maximum
Minimum
Regulator Setting
Dimensions (inches)
Heater (W x D x H)
Carton
9,500
Natural Gas
Piezo ignitor
Manual
12 lb.
13 lb.
14.0" W.C.
7.0" W.C.
6.0" W.C.
13” x 7-1/2” x 20-7/8”
15-1/4” x 9-1/4” x 24”
8
,500
LP Gas
Piezo ignitor
Manual
12 lb.
13 lb.
14.0" W.C.
11.0" W.C.
10.0" W.C.
13” x 7-1/2” x 20-7/8”
15-1/4” x 9-1/4” x 24”
CLEARANCES
You must provide adequate clearance around air openings to the heater. You also must provide for an adequate
combustion and ventilation air supply to the space to be heated. The heater must be easily accessible for servicing. The
opening for combustion air located at the bottom of the heater must not be obstructed.
The heater must be installed no less than 2" above the top surface of carpeting, tile or other floor covering. When facing
the front of the heater, the clearance from any combustible materials must be a minimum of 1
0
" from the left, 1
0
" from
the right, 36" from the top, and 2" from the bottom.
Never install the heater in front of any flammable object, especially do not place curtains, furniture, clothing or other
flammable objects less than 36” from the front of the heater.
FLOOR MOUNT INSTALLATION
This heater is designed to be installed on the floor using the optional floor stand kit PN 43603000. See instructions on
page 1
1
.
If this heater is to be installed directly on carpeting, tile or other combustible material other than wood flooring, the heater
shall be installed on a metal or wood panel extending the full width and depth of the heater. All other clearances to
combustible materials stated above must be maintained. Floor protection panels (PN 44058010) are available as an
accessory.
The panel referred to above does not mean the fireproof base as used on wood stoves. The protection is for rugs that are
extremely thick and light-colored tile that may discolor and to make sure the heater is level.
