sunstar corcho T (Convertido)-1 13/3/08 10:27 P gina 6
Composici n
C
M
Y
CM
MY
CY CMY
K
6
Model CK18M = (13-5/32 ) 334mm
Model CK30M = (20-45/64 ) 526mm
Min 15 380mm
Figure 2-1
BACK OF
HEATER
Min 22 5
5
5mm
20-
2/3
(5
12mm)
left side
Right side
Figure 2-2
Manual shut off valve
Gas line
Frank
U Hook
opening for combustion air
WALL MOUNT INSTALLATION
IMPORTANT:
Before installing this heater, make sure that a wall stud is located in the center of the
unit. This wall stud will give better support to the unit
. See the following instructions in
figure 2.2 to place the “C” angle to the wall stud:
1.
Select the elbow position as indicated in Figure 2-1.
2.
Use the template provided to mark out the hole locations.
3.
Drive two (2) 5/16” holes according to the dimensions shown on the upper corner of Figure 2-1.
4.
Drill another 5/16” hole on the wall stud for the “U” hook as shown in Figure 2-1.
5.
Screw in the three (3) plastic expansion anchors furnished with the unit, as shown in Figure 2-1.
6.
Screw in the furnished screws through the upper anchors as shown in Figure 2-1.
7.
Hang the appliance and screw the “U” hook to the wall with the furnished screw as shown in figure 2.2
8.
Connect the gas line.
