Quickie Pulse 6 Service Manual Contents
Introduction ....................................................0.1
Basic Setup ...................................................0.2
Multimeter Tutorial .........................................0.3
Health and Safety ..........................................0.5
Electro Static Discharge ................................0.8
Batteries ........................................................0.9
VR2 Remote Controller .................................0.12
VR2 Plugs/Connectors ..................................0.13
R-NET Remote Controller .............................0.14
R-NET Remote Controller .............................0.15
R-NET Plugs/Connectors ..............................0.16
Main Wiring Diagram VR2 .............................0.17
Main Wiring Diagram Rnet ............................0.18
Basic Tool List ...............................................0.19
Section1
Battery Connection Test ...................................1.1
Check Battery Wire Harness ............................1.2
Circuit Breaker Test ..........................................1.2
Main Harness ...................................................1.2
Section 2
VR2 Remote Controller Display........................2.1
The Maximum Speed Indicator Ripples............2.1
The Maximum Speed Indicator Flashes ...........2.1
Battery Gauge is Steady...................................2.1
Battery Gauge Flashes Slowly .........................2.1
Battery Gauge Steps Up...................................2.1
Battery Gauge Blinks Once Every 2.5 Seconds
..........................................................................2.1
Battery Gauge Flashes Rapidly .......................2.1
Section 3
VR2 Controller Diagnostic Codes .....................3.1
One Bar - Low Battery Voltage ) .......................3.1
Two Bars - Left Motor Disconnected ...............3.1
Three Bars - Left Motor Wiring Trip) .................3.2
Four Bars- Right Motor Disconnected ............3.3
Five Bars - Right Motor Wiring Trip ................3.4
Six Bars - Charger Connected........................3.4
Seven Bars - Possible Joystick Trip ..............3.4
Seven Bars + Speed Profile Indicator Communi-
cation Error ....................................................3.4
Eight Bars - Possible Control System Trip......3.5
Nine Bars - Solenoid Brake Trip .....................3.5
Ten Bars - High Battery Voltage ....................3.5
Section 4
R-net Troubleshooting Procedures ................4.1
Chair Will Not Power Up .................................4.1
Section 5
R-net Fault Codes .........................................5.1
Power Chair Displays a Fault on the Hand Con-
trol or Omni .....................................................5.1
Table 1, Error Codes.......................................5.1
Example of R-10 Fault Isolation .....................5.4
Power Chair Will Not Drive Full Speed .........5.4
Power Chair Will Not Drive in Creep Speed
When Tilted ....................................................5.6
Tilt Will Not Operate .......................................5.7
Section 6
Motor/Gearbox Inspection .............................6.1
Section 7
Removal Procedures .....................................7.1
Battery Removal ............................................7.1
Motor and Gearbox Removal ........................7.3
Control Module Removal ................................7.5
Shock Removal .............................................7.7
Front Caster Arm Removal ............................7.8
Rear Caster Arm Removal ...........................7.10
Front or Rear Caster Fork Removal ............. 7.11
Caster Removal ...........................................7.12
Tilt Actuator and Micro-Switch Removal .......7.13
