5
Step 6.
Assemble the canopy(S) on top frame(do not tighten),as
Fig6-1; Fully assemble top canopy(S1) on small top frame ,as
Fig.6-2 . Tie the bug netting around the top canopy to canopy and
then fully stretch canopy(S) and fix it to the end of corner connectors
(D), as Fig 6-3.
Step 5.
Use screw(DD),flat washer(EE) and Nut(CC) to joint top
pole(E) and center connector(F) ,as Fig 5-1
；
And then lift
the assembled top frame to insert the other end of the top
pole(E) into the corner connector(D)
，
as Fig.5-2
。
*After steps above, use screwdriver and wrench to tighten all
the hardware, but not too tight.
Step 7.
Use screw(DD),flat washer(EE)and plastic washer(FF) to fix
the glass side bar top(G) to Pole(A3 and A4) and then use
wrench(WW) to tighten the screw, but not too tight so that the glass
bar top can flip smoothly ; Insert the pin on the pole into the hole at
the end of the bar top support (H) and then put the dowel attached to
the little chain into the pin on the pole to set up the side bar top as
Fig 7. When not in use, the side bar top support (H) can go
separately with the poles and the top can stand vertically
Fig.5-2
E
D
Fig.6-1
Fig.6-2
Fig.6-3
S1
S
Fig.7
S1
S
Fig.5-1
