PUMP INSTRUCTIONS FOR 5720AH
PUMP INSTRUCTIONS FOR 5712 & 5720
1. Place the handle on the release valve and
rotate clockwise until the valve is closed
(hand tighten only).
3. To release pressure, remove the pump handle from
the cradle and use the handle to slowly turn the
release valve counterclockwise. The power unit
cylinder will retract and the press cradle will return
to the stored position.
2. Place the pump handle in the cradle.
Move pump handle up and down to
lower the carriage and apply force
to the item being pressed.
Note:
When not in use, store power unit with the piston in the fully retracted position and the release valve closed.
SHIPPING ADDRESS:
MAILING ADDRESS:
s
l
o
o
T
x
e
n
u
S
s
l
o
o
T
x
e
n
u
S
3
3
2
1
x
o
B
.
O
.
P
.
d
R
s
n
i
k
w
a
H
5
1
3
Travelers Rest, South Carolina 29690
Travelers Rest, South Carolina 29690
8
8-AH
WARNING
Never wire, clamp or otherwise disable the
lift control valve to function by any means
other than by using the operator’s hand.
TO OPERATE MANUALLY
5720AH can be operated manually or with pneumatic/ hydraulic assist. See step 8 (#1, 2, & 3) for manual operating instructions.
TO OPERATE WITH PNEUMATIC/ HYDRAULIC ASSIST
After step 7 (#9): Ensure the oil level is just below the oil filler plug hole. Re-install the oil filler plug.
Pour a teaspoon of good quality, air tool lubricant into the air supply inlet of the lift control valve.
Connect to air supply and operate for 3 seconds to evenly distribute lubricant. Check to ensure that the pump operates smoothly before putting into service.
Replace worn or damaged parts and assemblies as needed with manufacturer’s authorized replacement parts.
1. Place the handle on the release valve
and rotate clockwise until the valve
is closed (hand tighten only).
3. To end pneumatic operation, release
the grip on the air hose trigger.
2. To begin pneumatic operation, squeeze air
hose trigger until ram comes into contact
with the item to be pressed.
Air Hose Trigger
5712, 5720, 5720AH
rev. 10/03/18
7
5712
- 12 Ton Hydraulic Shop Press
5720
- 20 Ton Hydraulic Shop Press
5720AH
- 20 Ton Air/Hydraulic Shop Press
