Sundray Wireless AP-S800 Installation Guide
9 / 20
ü
You need to get the corresponding engineering drawing before beginning installation.
ü
AP-S800 series product should be installed at the specified site according to the engineering
drawing.
ü
Before installation, you need to check whether the installation site is suitable. If it is not
suitable, you can change the installation site but the distance between the new and the
specified sites on the engineering drawing cannot be greater than 1 meter.
ü
Record the MAC address and installation site of the access point(MAC address is on the side
panel of the AP), for example, MAC: 100D0E2020CDE1, location: on the top of the building
XXX.
3.2 Examining Installation Site
ü
Outdoor access point must be installed on a pole or a bracket. The pole and bracket must be
vertical. If the pole or bracket is made of iron, it should be protected from oxidation. The
installation site of the access point and its height must meet the design requirements.
ü
If an outdoor AP-S800 is installed on a pole on the top of a building, it cannot be suspended
outwards in the air.
ü
On the top of a building, outdoor AP-S800 should be installed in a place with less sunlight
exposure. If necessary, the corresponding sunproof protection can be applied to the device.
ü
If the access point has an Ethernet port supporting PoE, it should be installed outdoors with
that port facing down.
3.3 Installing Access Point
Access point is fixed on a pole through the pole mount kit. The outer diameter of the pole should
be between 48mm and 76mm. The pole mounting kit includes a mounting bracket and a fixing
plate, as shown below:
